Staytrem bridge replacement for AOM fitting pro...

Staytrem bridge replacement for AOM fitting procedure

 

 

 

Slacken or remove the strings and lift off the Adjusto-matic bridge

Picture_32

 

Unscrew the bridge mounts.

Picture_33

 

Screw in the new bridge mounting studs with the domed end facing upwards using the supplied Allen wrench .

Picture_35

 

Adjust the studs so that they are approximately 5mm below the surface, this is only an initial setting and is not critical.

Picture_36

 

Place the Staytrem bridge on the top of the mounting studs.

Picture_37

 

Refit and tighten the strings but do not tune the guitar yet.

Move the bridge so that the base plate is parallel with the face of the guitar body, in this position it will be free move with the action of the tremolo equally in either direction.

Picture_38

 

Using the supplied Allen wrench adjust the height of the bridge to obtain the correct action. Pass the Allen wrench through the holes at each end of the bridge to engage with the hexagon in the mounting studs. Turning clockwise will lower the bridge and turning anti-clockwise will raise the bridge.

Picture_39

 

Finally tune the guitar and set the intonation.